Emlid Hardware Setup

What you will need

• Hovermap unit

• Vehicle RTK or Backpack RTK mount

• Emlid RS3 GNSS receiver

• Emlid cable with wire loop (black Lemo connector)

Procedure

Step 1: Setup the RTK Mount and Receiver

1. Refer to the appropriate Knowledge Base article for instructions on how to set up your mount and attach the GNSS receiver:

   • Setup the Backpack RTK Mount and Receiver

   • Setup the Vehicle RTK Mount and Receiver

Step 2: Connect to Hovermap

1. The Hovermap and GNSS receiver should be attached to the Vehicle RTK or Backpack RTK mount.

2. Plug the Emlid cable with the wire loop into the receiver and the other end (black Lemo connector) into the Adaptor port.

Outcome

The Emlid RS3 receiver is now physically connected to Hovermap and ready for configuration.