As the Samsung Galaxy Active Tab tablet case is received still in its original wrapping, you will need to attach the mount receiver to the tablet case. This is the drill template that will help you attach the Emesent machined mount (SKU: A0021) to the Samsung tablet backing plate.
Click on the image to download the template.
The Samsung Galaxy Tab Active (2, Pro and 4) have been replaced by the Samsung Galaxy Tab S9 as Emesent's recommended tablet. The Galaxy Tab S9 no longer requires this mounting plate for compatibility with Emesent products. Consequently, this document is relevant only for users of these older Samsung Galaxy Tab Active Tablets.
Instructions
-
Print template at 100% on A4 paper in landscape.
- Remove the tablet from its case.
- Position the case face down on a flat surface so that the text "Samsung" is displayed upright.
- Position the printed template on the center of the case, with the dashed line aligned with the bottom edge of the case.
- Carefully drill six (6) 3mm holes into the case as marked by the cross hairs. Add sacrificial material under the case, if required, to protect the surface from damage.
- Add a shallow countersink to the holes on the inside surface of the Case. It must deep enough for an M3 countersunk screw to sit flush in the hole. A large ~10mm drill bit can be used for this operation.
- Fasten the Tablet Mount to the case with 6 (six) M3x6mm Countersunk Screws tightened to a torque of 1.2Nm. Lock and seal the screws using the Loctite 222.