Commander & Cortex Release

Prev Next

Commander 2.4 and Cortex 4.3

Release date: 19th November 2026

Always check the Supported Devices page before updating to ensure compatibility.

 

Overview

This release includes Commander 2.4.1 and Cortex 4.3.0. Commander 2.4.1 includes all changes of Commander 2.4.0, which Emesent did not release publicly. Hovermap ST, ST-X and GX1 now run the same Cortex release.

Each change below shows the scanners it applies to: all scanners, GX1, or Hovermap ST and ST-X.

 

Major changes

All scanners

Simpler installation. The scanner Board Support Package (BSP) and Cortex install as one package.

GX1

Vehicle mode. GX1 can scan from a moving vehicle. Vehicle mode sets up the cameras for a scan from a vehicle mount.

 

Minor changes

All scanners

Scanner address. Added emesent.internal as the default scanner address; hover.map is still supported.

GX1

Image quality. GX1 applies the camera tuning that matches the fitted lenses.

Wi-Fi. In China, Russia, Bahrain and Indonesia, GX1 uses the 2.4 GHz Wi-Fi band.

Hovermap ST and ST-X

RTK status. Commander shows the RTK status more clearly. Commander recognizes RTK for a backpack or a vehicle.

Spot. Connection improvements between Hovermap and Spot.

Wi-Fi password. Commander does not show the Wi-Fi password function for Hovermap in this release. The Web UI no longer has it. A changed password is kept when upgrading.

 

Resolved issues

All scanners

  • Commander keeps the path history and the scanner position if the connection is lost.

  • Mission reports show the correct duration for missions longer than 60 minutes.

  • The PPK selection persists when moving between pages of the mission workflow.

  • The Task Manager remains closed after it is collapsed.

GX1

  • The GNSS settings page shows only when it applies to the setup, and it shows the correct settings.

  • The "DJI app not registered" warning no longer shows with GX1.

Hovermap ST and ST-X

  • Improved network communication with the Freefly Astro.

  • DJI registration completes.

  • Commander no longer shows a false low battery warning when the scanner is on a drone.

 

Known issues and limitations

Please refer to the Known Issues and Limitations page for the most current information.

  • Spot (Hovermap): A Hovermap scan that starts before Spot has fully started can cause a Critical Battery warning. Workaround: Make sure that Spot has had enough time to start its internal component and compute system, so that Hovermap detects it correctly.

  • Wi-Fi password (Hovermap): Commander does not show the Wi-Fi password function for Hovermap. A Hovermap on Cortex 4.1.3 cannot change the password.

 

Next steps