Register App (for DJI drones)

Emesent Commander app registration is an important step in establishing a vital connection between the app and the robot (when connected to a Hovermap) allowing for effective communication and control. This initial registration serves as a crucial safety measure, preventing potential accidents and ensuring the smooth operation of your robot in various environments.

Internet connection is required to register the Emesent Commander app.

If you are using a DJI drone, you must enable the Allow registration with DJI to use DJI drones option to allow automatic detection of the DJI drone while connected to Emesent Commander.

Registration with DJI allows the configuration of remote controls, geofence information, and flight control settings required for the autonomous control of DJI drones when they are connected to your Hovermap.

DJI registration can be enabled in two places:

• The user information page, shown the first time the app is run

• The Application Settings page, accessed from the Options menu in Commander

Procedure

Step 1: Enable DJI registration

1. Open Commander.

2. Tap the Hamburger button in the top-left corner to open the Options menu.

3. Select Application Settings.

4. Select Allow registration with DJI to use DJI drones.

Step 2: Connect to the internet and launch Commander

1. Connect the tablet to a Wi-Fi network with internet access.

2. Launch Commander.

3. Confirm that the DJI: App is not registered notification is not displayed.

Outcome

Commander is registered with DJI and automatically detects the DJI drone when it is connected to Hovermap.

Additional information

The DJI: App is not registered notification is shown only when Allow registration with DJI to use DJI drones is enabled and the tablet has no internet connection.

To clear the notification, connect the tablet to a Wi-Fi network with internet access.

The notification appears in these locations: