Emesent Commander communicates directly with the Hovermap ST-X via the Freefly PilotPro controller. Connection to the Hovermap’s Wi-Fi network is not required.
Hold the power button on the Pilot Pro tablet for 4 seconds. This will power on both the tablet and the controller. Press again when prompted on the controller to complete powering on.
Turn off the Wi-Fi on the Pilot Pro tablet.
Emesent Commander communicates directly with the Hovermap ST-X via the Freefly PilotPro controller. Connection to the Hovermap’s Wi-Fi network is not required. The Wi-Fi on the Pilot Pro tablet must be disabled.
Power on your Hovermap.
As stated in the next step, perform this step before launching the Emesent Commander app.
Launch Emesent Commander then tap Connect to display the Network Settings page.
If the app has been opened before powering on your Hovermap, you need to restart the app.
Set Hostname to 192.168.144.101 then tap the tick button to connect.
6. Once the connection is established, you will hear an audio message indicating that you are “Connected” and the mission tiles are enabled.