--- title: "Start a scan in Commander" slug: "start-a-gx1-scan-in-commander" updated: 2026-08-24T05:26:55Z published: 2026-08-24T05:26:55Z canonical: "knowledge.emesent.com/start-a-gx1-scan-in-commander" stale: true --- > ## Documentation Index > Fetch the complete documentation index at: https://knowledge.emesent.com/articles/llms.txt > Use this file to discover all available pages before exploring further. # Start a scan in Commander This article explains how to set up and start a mapping scan using the GX1 in Commander. ## What you will need - Active mapping license - Commander connected to a GX1 - GX1 powered on and mounted in a supported configuration: survey pole, backpack, supported handheld, or vehicle - Battery with sufficient charge for the planned mission - If using RTK: a configured NTRIP profile on the GX1 and in Commander Before starting this procedure, review the [mission plan](/v1/docs/plan-a-gx1-mission) and [scan techniques](/v1/docs/gx1-scanning-techniques). ## Step 1: Open a new mission 1. Navigate to the new mission page in Commander. 2. If the new mission page does not display, open the **Options Menu** and select **New Mission**. 3. Select the **Non-Autonomous Mapping Mission** icon. ## Step 2: Configure GNSS settings 1. In the **GNSS Settings** section, select the options for the scan type: - If performing an RTK scan, enable **Enable RTK during Scan**. 2. If using RTK, select an NTRIP profile. [If none are available, create one by selecting +New](/v1/docs/configure-an-ntrip-profile). 3. Confirm a good GNSS position before continuing. ## Step 3: Configure scan settings 1. Check the scanner status displays **Scanner standby, waiting for scan to start**. 2. Enter a scan name that clearly describes the scan. Use a consistent naming convention when collecting multiple scans to simplify file management after the mission. 3. Check sufficient storage is available for the planned mission. 4. Select a camera mode. Choose **Record and Stream** to capture and view video during the scan, or **Off** to scan without camera input. ## Step 4: Start the scan 1. Select **Start Scan**. 2. The LiDAR Sensor begins rotating, the GX1 emits an audible tone, and the **Status Indicator Ring** rotates in blue. 3. The GX1 runs pre-scan checks for approximately 60 seconds. ## Step 5: Check pre-scan results 1. When the pre-scan checks complete, Commander switches to the live point cloud view. 2. The GX1 is ready to begin the mission. ## Outcome After these steps, the GX1 is actively scanning and capturing mission data. Commander displays the live scan view, and the GX1 continues until the scan is stopped.