--- title: "Scan data storage" slug: "gx1-scan-data-storage" updated: 2026-10-13T22:40:23Z published: 2026-10-13T22:40:23Z canonical: "knowledge.emesent.com/gx1-scan-data-storage" stale: true --- > ## Documentation Index > Fetch the complete documentation index at: https://knowledge.emesent.com/articles/llms.txt > Use this file to discover all available pages before exploring further. # Scan data storage This article describes how the GX1 stores scan data and how to manage capacity across a deployment. The GX1 has 2TB of internal storage, which holds approximately 40 hours of scanning at full camera resolution. ## What is it? The GX1 stores scan data internally during a mission, then offloads it to the kit-included Portable SSD T7 Shield for transfer to a host computer and processing in Aura. ## Capacity How quickly storage fills depends on which sensors are recording. | Sensor combination | Approximate data rate | | --- | --- | | LiDAR with full camera capture | Up to 50 GB per hour | | LiDAR only | Approximately 10 GB per hour | ## Expand storage with a microSD card > [!CAUTION] > Please note this function is not currently supported but will be in future Cortex releases. The GX1 has a microSD Card Slot in the Battery Carrier, next to the SIM Card Slot. Insert an exFAT-formatted microSD card to expand storage by up to 2TB, in addition to the 2TB internal SSD. When a microSD card is installed, the GX1 records scans to the microSD card first. ## Why it matters Storage capacity is the second constraint after battery runtime. Monitoring capacity and offloading data between sessions prevents data loss and downtime. ## How it works Scan data is offloaded over USB-C to the Portable SSD T7 Shield, then transferred to a host computer for processing in Aura. For the offload procedure, see [Offload GX1 scan data](/v1/docs/offload-gx1-scan-data). ## Where storage capacity is shown Commander shows the storage bar on the scan setup page. Storage notifications also appear on the 3D view during a scan. ![](https://cdn.document360.io/c908b593-57d7-4fc8-b409-592fc1051369/Images/Documentation/image(594).png) As storage approaches full, Commander displays warnings: | Warning | Threshold | Restriction | | --- | --- | --- | | Low | 200 GB remaining | None | | Critical | 50 GB remaining | Cannot start a new scan until storage is offloaded | ## Best practices | Do | Don't | | --- | --- | | Offload scan data between sessions. | Wait for storage to be nearly full before offloading. | | Check remaining capacity in Commander before every mission. | Start a long mission without confirming sufficient capacity. | | Plan offload time into multi-day deployments. | Treat storage as effectively unlimited. | ## Related articles - [Offload GX1 scan data](/v1/docs/offload-gx1-scan-data) - [Start a GX1 scan in Commander](/v1/docs/start-a-gx1-scan-in-commander)