--- title: "Scenarios" slug: "scenarios" status: "update" updated: 2026-10-19T01:48:03Z published: 2026-10-19T01:48:03Z canonical: "knowledge.emesent.com/scenarios" --- > ## Documentation Index > Fetch the complete documentation index at: https://knowledge.emesent.com/articles/llms.txt > Use this file to discover all available pages before exploring further. # Scenarios The articles in this section describe common scenarios for Hovermap. Each article gives the important considerations, the recommended techniques, and the settings for that scenario. > [!NOTE] > Every site is different. Use these practices as a guide, and adjust them for the environment. ## In this section ### Underground - [Scan a stope](/v1/docs/scanning-a-stope-1): Use Autonomous mode in an inaccessible stope. - [Scan a shaft](/v1/docs/scanning-a-shaft): Scan a shaft, raisebore, or ore pass with Hovermap in its protective cage. ### Structures - [Scan a bridge](/v1/docs/scanning-a-bridge): Plan a bridge scan to prevent SLAM slips over water. - [Scan buildings](/v1/docs/scanning-buildings): Plan a scan of the outside and the inside of a building. - [Scan power lines](/v1/docs/scanning-power-lines): Get consistent scans of power lines and towers. ### Large and linear areas - [Scan a large outdoor area](/v1/docs/scanning-a-large-outdoor-area): Plan the mission path for large areas with few features. - [Scan a long, linear environment](/v1/docs/long-and-linear): Scan a long route, such as a road or a tunnel.