--- title: "Power from an external source" slug: "power-gx1-from-an-external-source" updated: 2026-08-24T05:26:55Z published: 2026-08-24T05:26:55Z canonical: "knowledge.emesent.com/power-gx1-from-an-external-source" stale: true --- > ## Documentation Index > Fetch the complete documentation index at: https://knowledge.emesent.com/articles/llms.txt > Use this file to discover all available pages before exploring further. # Power from an external source This article explains how to power the GX1 from an external source through the USB-C Port on the GX1 Control Panel. External power runs the GX1 without relying on the battery and charges an installed battery while connected. ## Prerequisites - A GX1. - A USB-C charger rated at 65W or higher, and a USB-C cable that supports it. The USB-C cable is not included with the GX1. - A battery does not need to be installed to run the GX1 on external power. ## Procedure ### Step 1: Connect external power 1. Connect the USB-C cable to the external power source. 2. Connect the other end to the USB-C Port on the GX1 Control Panel. ### Step 2: Confirm the GX1 is receiving power 1. Confirm the orange Power Button light illuminates. This indicates the GX1 is receiving power. 2. Power on the GX1. See [Power GX1 on and off](/v1/docs/power-gx1-on-and-off). 3. Check the Status Indicator Ring on the GX1. See [GX1 status indicator ring](/v1/docs/status-indicator-ring). ## Outcome The GX1 is running on external power, and an installed battery charges while external power is connected. Use external power for charging, scan offload, and other non-scan tasks. Run the GX1 on battery for a scan. ## Additional information - Do not power the GX1 over USB-C during a scan. Run the GX1 on battery power for a scan. - The USB-C Port is also used for scan offload and firmware upgrades. - To charge GX1 batteries outside the device, see [Charge GX1 batteries](/v1/docs/charge-gx1-batteries).