--- title: "Emlid" slug: "emlid-setup" status: "update" updated: 2026-08-24T05:23:49Z published: 2026-08-24T05:27:12Z canonical: "knowledge.emesent.com/emlid-setup" stale: true --- > ## Documentation Index > Fetch the complete documentation index at: https://knowledge.emesent.com/articles/llms.txt > Use this file to discover all available pages before exploring further. # Emlid These videos complement this setup guide to show you how to configure and set up supported Emlid receivers (RS2, RS2+, RS3) for use with Emesent's Backpack or Vehicle RTK units, view the RTK status in Commander, and process your scan in Aura. | [YouTube video player](https://www.youtube.com/embed/9TwxDQsB5E8?si=P8FyjDcE85suuVfU) | [YouTube video player](https://www.youtube.com/embed/Inj4pwL3BYQ?si=pRXGMx7cKJElgx8J) | | --- | --- | ## **Overview** This document shows how to configure and setup supported Emlid receivers for use with Emesent's Backpack or Vehicle RTK units and then monitor and process the RTK data. Backpack and Vehicle RTK automates high-accuracy georeferencing and drift correction for scans, allowing for rapid and precise scans without the need for ground control points. ## **Scope** Follow the instructions in this document once you have setup your Emlid device according to Emlid documentation. This document does not cover how to perform an initial setup on an Emlid RS2, RS2+, or RS3 receiver or how to connect to a base station or network corrections service. To perform these actions, please refer to Emlid's official documentation for the Emlid RS2+. The Georeferencing articles and videos in Knowledge Base expand on the information and instructions presented in this document, including: - [Best Practice for RTK](/v1/docs/best-practice-for-rtk) - [Troubleshooting RTK](/v1/docs/troubleshooting-rtk) - [Recommendations for Vehicle RTK](/v1/docs/best-practice-for-vehicle-rtk) ##