--- title: "Calibrating the Drone Compass (DJI only)" slug: "calibrating-the-drone-compass-dji-only" updated: 2026-08-24T05:26:44Z published: 2026-08-24T05:26:44Z canonical: "knowledge.emesent.com/calibrating-the-drone-compass-dji-only" stale: true --- > ## Documentation Index > Fetch the complete documentation index at: https://knowledge.emesent.com/articles/llms.txt > Use this file to discover all available pages before exploring further. # Calibrating the Drone Compass (DJI only) This article explains how to calibrate the drone compass using the Mission Workflow in Emesent Commander. Use this procedure to ensure the compass is accurately calibrated before takeoff. > [!NOTE] > Compass calibration in Emesent Commander can only be started when the drone requires calibration. If calibration is required outside of the Mission Workflow, you can start it manually through DJI Pilot 2. ## What you will need - DJI drone with Hovermap connected and set up - Supported tablet with Emesent Commander installed ## Procedure ### Step 1: Start a mission 1. From the Emesent Commander landing page, tap the **Assisted Mission** tile or the **Autonomous Mission** tile. ### Step 2: Complete pre-mission checks 1. Complete all required pre-mission checks. 2. Tap **Continue**. ### Step 3: Check for a calibration notification 1. On the **Connectivity** page, check for a compass calibration notification. ![](https://cdn.document360.io/c908b593-57d7-4fc8-b409-592fc1051369/Images/Documentation/image(154).png) ### Step 4: Start compass calibration 1. Tap **Calibrate Compass**. ![](https://cdn.document360.io/c908b593-57d7-4fc8-b409-592fc1051369/Images/Documentation/image(155).png) ### Step 5: Complete the calibration 1. Follow the on-screen instructions. 2. Rotate the robot vertically, then horizontally, as directed. | ![](https://cdn.document360.io/c908b593-57d7-4fc8-b409-592fc1051369/Images/Documentation/image(164).png) | ![](https://cdn.document360.io/c908b593-57d7-4fc8-b409-592fc1051369/Images/Documentation/image(160).png) | | --- | --- | ### Step 6: Confirm successful calibration 1. Check the screen for a message confirming the calibration was successful. 2. Tap **Close Calibration** to return to the **Connectivity** page. ![](https://cdn.document360.io/c908b593-57d7-4fc8-b409-592fc1051369/Images/Documentation/image(158).png) ### Step 7: Continue the mission workflow 1. Proceed with the remaining Mission Workflow steps. Refer to the [Mapping, Pilot Assist, or Autonomous Mission](/v1/docs/how-to-perform-a-mission-mapping-autonomy) section for more information. ![](https://cdn.document360.io/c908b593-57d7-4fc8-b409-592fc1051369/Images/Documentation/image(159).png) ## **Outcome** After completing these steps, the drone compass is calibrated and you can continue with the Mission Workflow.