--- title: "Leica Hardware Setup" slug: "04-leica-setup" updated: 2026-08-24T05:26:55Z published: 2026-08-24T05:26:55Z canonical: "knowledge.emesent.com/04-leica-setup" stale: true --- > ## Documentation Index > Fetch the complete documentation index at: https://knowledge.emesent.com/articles/llms.txt > Use this file to discover all available pages before exploring further. # Leica Hardware Setup This article explains how to connect a Leica GS18 GNSS receiver to a Hovermap with the Vehicle RTK or Backpack RTK mount. Use this procedure to prepare the hardware before the receiver settings are configured. ## What you will need - Hovermap unit - Vehicle RTK or Backpack RTK mount, assembled. Refer to [Backpack RTK hardware setup](/v1/docs/hardware-setup-1) or [Vehicle RTK hardware setup](/v1/docs/hardware-setup). - [Supported Leica GNSS receiver](/v1/docs/3rd-party-recievers) - GNSS adaptor cable - Leica cable (black Lemo connector) - 100 mm spacers x2 (Leica GS18 with Backpack unit only) ## Procedure ### Step 1: Connect to Hovermap 1. Confirm that the Hovermap and the GNSS receiver are attached to the Vehicle RTK or Backpack RTK mount. | ![](https://cdn.document360.io/c908b593-57d7-4fc8-b409-592fc1051369/Images/Documentation/04_leica_setup-image-6gcjsf9y.png) | ![](https://cdn.document360.io/c908b593-57d7-4fc8-b409-592fc1051369/Images/Documentation/04_leica_setup-image-eqrbakfv.png) | | --- | --- | > [!WARNING] > When the Leica GS18 is used with the Backpack unit, use both 100 mm spacers. This gives a total offset of 200 mm and makes sure that the offset in Aura is correct. ### Step 2: Connect the GNSS adaptor cable 1. Plug the GNSS adaptor cable into the RTK mount. 2. Fasten the adaptor to the magnetic plate. ![](https://cdn.document360.io/c908b593-57d7-4fc8-b409-592fc1051369/Images/Documentation/04_leica_setup-image-jpmvvhoa.png) ![](https://cdn.document360.io/c908b593-57d7-4fc8-b409-592fc1051369/Images/Documentation/04_leica_setup-image-s6avb6x4.png) ### Step 3: Connect the Leica cable 1. Plug the Leica cable into the receiver. 2. Plug the other end (black Lemo connector) into the GNSS adaptor port. | ![](https://cdn.document360.io/c908b593-57d7-4fc8-b409-592fc1051369/Images/Documentation/04_leica_setup-image-0er6nc3h.png) | ![](https://cdn.document360.io/c908b593-57d7-4fc8-b409-592fc1051369/Images/Documentation/04_leica_setup-image-725tpgw0.png) | | --- | --- | ## Outcome The Leica receiver is mounted and connected to the Hovermap. The receiver settings must be configured before a scan. ## Additional information - [Configure Leica receiver](/v1/docs/configure-leica-reciver): set the NMEA, tilt, and antenna settings. Do this next. - [Supported GNSS receivers](/v1/docs/3rd-party-recievers): the Leica models supported by Backpack RTK and Vehicle RTK. - [Troubleshooting RTK](/v1/docs/troubleshooting-rtk): diagnose RTK setup and processing issues.